Multiquip TP7X operation manual Shut down Procedure, Wait for the cutting blade to stop rotating

Page 23

operation

3.Push the cutting table with the material, slowly and evenly until the cut is complete. Move the cutting table back and remove the cut pieces.

4.Avoid overloading the motor when cutting. However, the electric motor is protected with a manual-reset thermal overload switch that will turn the saw off if the motor is overheated. In the event that the switch is tripped, turn the “ON/OFF” switch to the “OFF” position and allow the motor to cool before attempting to restart.

Shut down Procedure

1.Place the power ON/OFF switch (Figure 16) in the OFF position (down).

Figure 16. Power ON/OFF Switch (OFF)

2.Wait for the cutting blade to stop rotating.

3.Disconnect the saw's AC power cord from the power source. NEVER leave the saw connected to a power source when unattended. This will prevent accidental starting.

4.Using a soft cloth, clean any excess debris or residue that may have accumulated on the saw.

5.Store saw in a clean dry location where it will be out of the reach of children.

TP7X TILE SAW • operation manual — rev. #0 (03/04/11) — page 23

Image 23

Contents Model TP7X Proposition 65 Warning Silicosis Warning Silicosis/Respiratory WarningsSawing Guides Table of ContentsSpecifications are subject to change without notice Page SaFeTy meSSageS Safety InformationGeneraL SaFeTy BLaDe SaFeTy SaW SaFeTyTranSporTIng SaFeTy ELeCTrIC moTor SaFeTyPower Cord/Cable Safety LIFTIng SaFeTyElectric Motor Specifications Saw SpecificationsDimension DimensionsDry Cutting Applications Accessories/Replacement PartsFeatures General informationPage Saw Components Saw componentsStopper Place stopper in water tray when filling with water Saw Set-Up Support Stand Assembly OptionalElectric motor components/set-up Electric Motor ComponentsRefer to Figure Connecting the water PumpInstall drain plug in water tray Set-upBlade Diameter vs. Cutting Depth BladesBlade Components Cutting DepthProper Blade Use Blade InstallationSee for proper blade use guidelines Set-up/sawing guides Connecting the PowerSawing Guides Using the Cutting Table Using the MasterGuide Template BasePerforming Miter Cuts Using the Rip GuideSawing guides Performing Diagonal CutsStarting or attempting to operate the saw Start-up ProcedureOperation Wait for the cutting blade to stop rotating Shut down ProcedureInspect the cutting table periodically. Replace worn parts Basic MaintenanceAfter not using the machine for a prolonged period of time Maintenance intervalsAfter wet cleaning and before using the machine again Before not using the machine for a prolonged period of timeBearing housing removal Water pump maintenanceBelt Replacement Bearing Housing Removal Bearing Housing InstallationElectric Motor Wiring Diagram Wiring diagram electric motorPage Blade Troubleshooting Troubleshooting bladeSaw Troubleshooting Troubleshooting SawHERE’S HOW to GET Help