Multiquip TP7X operation manual Bearing Housing Installation, Bearing Housing Removal

Page 27

MAINTENANCE

Figure 19. Bearing Housing Removal

Bearing Housing Installation

To install a new bearing housing, perform the following:

1.Make sure that the old housing has been properly removed.

2.Unpack the new bearing housing and place the flat portion face-down on a towel situated on a flat surface.

3.Secure the cutting head in a in a completely horizontal position.

4.Slide the new bearing housing with the flat portion facing upwards onto the 4 screws located below the mounting plate. Take care not to damage the inner flange. Lock the bearing housing into place by using the brackets and nuts.

5.Pull the motor towards you, place the belt on the pulleys, and tighten the motor position adjustment screw. Be sure to leave some slack on the belt.

6.Align the belt by adjusting the motor pulley after loosening the hex screw.

WARNING

Do not adjust the bearing housing pulley.

7.After aligning the belt, tighten the hex screw.

8.Replace the belt guard and lock into place using 4 screws.

TP7X TILE SAW • operation manual — rev. #0 (03/04/11) — page 27

Image 27

Contents Model TP7X Proposition 65 Warning Silicosis Warning Silicosis/Respiratory WarningsTable of Contents Specifications are subject to change without noticeSawing Guides Page SaFeTy meSSageS Safety InformationGeneraL SaFeTy BLaDe SaFeTy SaW SaFeTyTranSporTIng SaFeTy ELeCTrIC moTor SaFeTyPower Cord/Cable Safety LIFTIng SaFeTyElectric Motor Specifications Saw SpecificationsDimension DimensionsDry Cutting Applications Accessories/Replacement PartsFeatures General informationPage Saw Components Saw componentsStopper Place stopper in water tray when filling with water Saw Set-Up Support Stand Assembly OptionalElectric motor components/set-up Electric Motor ComponentsRefer to Figure Connecting the water PumpInstall drain plug in water tray Set-upBlade Diameter vs. Cutting Depth BladesBlade Components Cutting DepthBlade Installation See for proper blade use guidelinesProper Blade Use Set-up/sawing guides Connecting the PowerSawing Guides Using the Cutting Table Using the MasterGuide Template BasePerforming Miter Cuts Using the Rip GuideSawing guides Performing Diagonal CutsStart-up Procedure OperationStarting or attempting to operate the saw Wait for the cutting blade to stop rotating Shut down ProcedureInspect the cutting table periodically. Replace worn parts Basic MaintenanceAfter not using the machine for a prolonged period of time Maintenance intervalsAfter wet cleaning and before using the machine again Before not using the machine for a prolonged period of timeWater pump maintenance Belt ReplacementBearing housing removal Bearing Housing Removal Bearing Housing InstallationElectric Motor Wiring Diagram Wiring diagram electric motorPage Blade Troubleshooting Troubleshooting bladeSaw Troubleshooting Troubleshooting SawHERE’S HOW to GET Help