Lock/Unlock, Factory Mode, Burn In, Service Mode | 107T5 |
| 13 |
Go to cover page
OSD lock is a feature which disables the OSD controls. It can be used when the monitor is set up for demonstration purposes or when
adjustment of the OSD is not desirable.
Press and hold the button continuously for 15 seconds. Release the button when the message
"CONTROL MENU IS LOCKED" appears.
Press and hold the button continuously for 15 seconds or until the message window "CONTROL MENU IS LOCKED" disappears, and
"MAIN CONTROLS" appears.
1.Turn off monitor (don't turn off PC)
2.Press '" " and " " simultaneously on the front control
panel,then press " ",wait till the OSD menu with characters V30 107T5 V0.48 20021218 (below OSD menu)" come on the screen of monitor.
First of all, monitor displays an image.
1.Disconnect the video cable (interface cable).
2.Turn off monitor
3. Press '" " and " " simultaneously on the front control panel,then the BURN IN mode comes on the screen of monitor as below.
50 seconds around
5 seconds around
repeatly
02060 |
02060: stands for
1. using 10 hours already.
2. turn on/off 10 times.
3. using several hours + turn on/off monitor.
MODEL SELECT
V30 107T5 V0.48 20021218
MODEL SELECT
107T5
107B5 RESERVE RESERVE RESERVE SWDDC LF 3
Factory
Mode
Indicator
3.If OSD menu disappears on the screen of monitor, press " " again (anytime), then the OSD menu comes on the screen again.
4.Using " " : to select OSD menu.
5. Using " " : to increase or decrease the setting.
6. Using " " to access/confirm the selection.
7.After alignment of factory mode, turn off monitor (if you do not turn off monitor, the OSD menu is always at the factory mode), then turn on monitor again (at this moment, the OSD menu goes back to user mode).