DDC Instructions
107T5 | 25 |
Go to cover page
Step 9: Load DDC data | Note 2 : In Factory Mode: Read/Write DDC data | |
|
| Before Read/Write EDID code, please confirm that the |
1. Click | from the tool bar. | Software DDC only was enabled as shown in Fig. 23. |
2.Select the file you want to open as shown in Fig. 20.
3.Click Open.
4.Access "Factory Mode" and enable "Software DDC only" as shown in Fig. 17 & Fig. 16.
5.Write EDID (click 
).
Fig. 23
Fig. 20
Step 10: Exit DDC program
Pull down the File menu and select Exit as shown in Fig. 21. (EDID Tool 3.01)
Fig. 21
Note1 : In User Mode: Read DDC data only
Before read EDID code, please confirm that the Software
DDC only was disabled as shown in Fig. 22.
Fig. 22
If you do not disable "Software DDC only", when you execute "read EDID", it will bring up an error message as below.
