Philips V30 manual For 6500 K 015, For SRGB = 0.313

GENERAL PRODUCT SPECIFICATION

107T5 59

Go to cover page

4.8Mis-convergence

The maximum convergence error to be measured on a white spot or white display line to represents the maximum distance between the energy centers of any two primary colors (See Fig. 6). For 31.5kHz modes B Zone : 0.4mm.

CONVERGENCE SPEC.

Zones

0.25 mm CRT

Zone C

0.15 mm

Zone A

0.25 mm

Zone B

0.35 mm

4.9Focus check ( 68.7 KHZ / 85 HZ )

Adjust brightness control to center(50%) and contrast control to get 25 FL

at full white pattern, then generate “me” characters to cover the entire picture. The characters should be clearly identified in all display area. (See Fig. 8)

4.10Luminance uniformity

condition : With full white pattern, set contrast control at maximum(100%) and brightness control at center(50%).

Brightness of the center of the display is 30 FL+/-5.

The Max. deviation over the screen should not exceed 25% .

4.11 White color adjustment

Based on the 1931 CIE chromatic diagram (x,y) coordinates of white display on screen center should be:

For	9300° K	X	= 0.283	￿ 0.015
		Y	= 0.297	￿ 0.015
For	6500° K	X	= 0.313	￿ 0.015
		Y	= 0.329	￿ 0.015
For	sRGB X	= 0.313 ￿ 0.015
		Y	= 0.329	￿ 0.015

Check conditions : Set brightness control at center(50%) and contrast at maximum(100%).

For sRGB mode sRGB contrast is at Factory value.

4.12Color tracking on full white pattern

Adjust for the luminance output from 3 to 30 FL by pressing the contrast control key (brightness control at 50%). The color co-ordinates should not deviate more than the following tolerance when compare to display center:

X= X (center) ￿ 0.015 Y= Y (center) ￿ 0.015

17" V30 GS4 107T5-71K CMTR

			TYPE	: 107T51/00
			BRAND	: PHILIPS
2003-	01-07
		Wayne Lin		30	590	17
				2003-01-07