Multiquip TP24X manual Electric motor components/set-up, Electric Motor Components, Saw set-up

electric motor components/set-up

Electric Motor Components

Figure 3 shows the location of the components of the electric motor.

115 VAC, 60 Hz

SINGLE -PHASE

ELECTRIC MOTOR

OVERCURRENT

BREAKER BUTTON

ELECTRIC WATER	ELECTRIC
PUMP AC	MOTOR
RECEPTACLE	ON/OFF SWITCH

Figure 3. Electric Motor Components

Saw set-up

WARNING

Whenever cleaning, adjusting or lubricating any part of the saw, make certain to place the power ON/OFF switch in the OFF position and disconnect the plug from the power source.

1.Open the shipping container carefully, lift the saw by its carrying handles and place it on a suitable table or platform. Make sure the table or platform can support the weight of the saw.

2.Make sure that the following items are found in the container:

„„Saw	„„Water Pump
„„Water Tray	„„Rear Drip Tray
„„Drain Plug	„„Owner’s Manual
„„Universal Wrench	„„MasterGuide Template
„„Saw Blade	Base

3.If using the optional support stand, assemble as described in the Support Stand Assembly section. Make sure that the saw is secured on the support stand as instructed.

support Stand Assembly (Optional)

Refer to Figure 4 for location of components.

1.Remove the two lock pins inserted through the sides of the stand. While holding the stand upright, spread both sets of legs apart and swing the workbench over and on top of the legs.

2.Insert lock pins through the legs and into the workbench. After saw stand is completely assembled, place the saw on top of the saw stand and secure the saw frame in place by screwing the two knobs (one on each side) under the saw frame.

WING BOLT

LOCK PIN

Figure 4. Support Stand Assembly

page 16 — TP24X TILE SAW • operation and parts manual — rev. #2 (04/12/12)