Northern Industrial Tools 164612 manual Setup/Assembly, Illustration Of Complete Assembly

Page 12

4.3 Illustration Of Complete Assembly

5. Setup/Assembly

ATTENTION: The protection class of the MIG 175 Portable Wire Feed Welder is IP21S. Do not insert any object that is less than 12.5 mm (especially a metal bar) into the welder. The case is not designed to be stood on or to have heavy objects placed on top of it.

WARNING! Do not switch voltage while welding. Only the operator should adjust the welding parameters.

WARNING! The welder must be grounded before using. Do not remove the ground earth clamp while welding or you may get an electric shock. When multiple welders are using a common grounding device, they must have a parallel connection and must not connect in series. The welder’s ground cable sectional area should not be smaller than the input power cable.

Weld only in areas free from dust, chemicals, flammable or explosive gases and other similar substances.

This welder is designed for use and storage indoors or in a covered area at 10°F–105°F. If used outside, unit should not be exposed to rain or high humidity.

Only weld in a well-ventilated area where smoke and fumes can be avoided. Use a smoke ventilation device if necessary.

5.1 Electrical Power

*Plug in power cord to a 230 Volt 15 amp circuit..

5.2 Shielding Gas Connection.

*Read Gas Bottle Safety Section on proper care and handling of compressed gases.

*Install regulator to gas bottle and connect the gas line between the regulator and the gas solenoid valve found in the back of the welder.

*Secure gas hose with clamps to ensure there are no leaks.

10

Page 11 Page 13
Image 12
Page 11 Page 13
Contents MIG Save this Manual General Welding Safety Product Description Technical SpecificationsWelder Specifications InstallationGeneral Welding Safety Your Welding EnvironmentYour Welder’s Condition Use of Your Welder4B Fumes and Gases 4C UV and IR Arc Rays 4D Fire Hazards4E Hot Materials 4I Proper Care, Maintenance And Repair 4F Sparks/Flying Debris4G Electromagnetic Fields 4H Shielding Gas Cylinders Can ExplodeTechnical Specifications Required Power SupplyProduct Description Proper Environment for Welder Symbol Explanations MIG Gun IllustrationWelder Specifications Main Technical Data See TableStructure of Welder Top View Front View Left View Setup/Assembly Illustration Of Complete AssemblyElectrical Power Shielding Gas ConnectionOperation Connection Between Drive System and TorchConnection of the Gun Trigger Leads and Ground Cable Work Piece Cleaning before Welding Adjustment and Test before WeldingMaintenance and Service WeldingTroubleshooting Troubleshooting See TableCommon Weld Defects See Table Circuit Chart Quality Guarantee Packing ListTransport & Storage Illustrated Parts List Warranty Northern Tool + Equipment Co
Top Page Image Contents