PYLE Audio C6110 instruction manual Storage

Page 17

STORAGE

Before you store the air compressor, make sure you do the following:

1.Review the "Maintenance" section on the preceding pages and perform scheduled maintenance as necessary.

2.Set the On/Auto/Off lever to "Off" and unplug unit.

3.Turn the regulator counterclockwise and set the outlet pressure to zero.

4.Remove the air tool or accessory.

5.Pull ring on safety valve allowing air to bleed from the tank until tank pressure is approximately 20 psi. Release safety valve ring.

6.Drain water from air tank by opening drain valve on bottom of tank.

Risk of Bursting. Water will condense in the air tank. If not drained, water will corrode and weaken the air tank

causing a risk of air tank rupture.

7.After the water has been drained, close the drain or drain valve.

NOTE: If drain valve is plugged, release all air pressure. The valve can then be removed, cleaned, then reinstalled.

8.Protect the electrical cord and air hose from damage (such as being stepped on or run over). Wind them loosely around the compressor handle.

9.Store the air compressor in a clean and dry location.

17- ENG

A10244

Page 16 Page 18
Image 17
Page 16 Page 18
Contents C6110 ModelImportant Safety Instructions Safety Guidelines DefinitionsOr serious injury Or moderate injury Death or serious injuryAlways remain in attendance with What Could HappenAttachments & Accessories Electricity. Like any other electrically Safety equipment must be properlyRepairs attempted by unqualified Personnel can result in serious injuryHazard Warning Risk from Moving Parts Result in serious burns How To Prevent ItEquip area of operation with a fire extinguisher Keep children away from the air compressor at all timesAccessories SpecificationsGlossary Duty CycleInstallation AssemblyUnpacking Location of the Air CompressorVoltage and Circuit Protection Extension CordsKnow Your Air Compressor Description of Operation OperationHow to Stop How to Use Your UnitHow to Start MaintenanceBefore Each Start-Up Customer Responsibilities Air Filter Inspection and Replacement To Check Safety Valve To Drain Tank Air Compressor Pump Intake and Exhaust ValvesTo Replace or Clean Check Valve Service and AdjustmentsTo Replace Regulator Storage Troubleshooting Being used Check wiring connection ENG A10244 Limited Warranty
Top Page Image Contents