PYLE Audio 324MAG instruction manual LINE-OF-CUT Indicator, Using the Exhaust Nozzle

3.To adjust, loosen the bevel-adjustment knob (A) Fig. 8. While keeping the bevel stop (B) Fig. 8 in contact with the stop screw (C) Fig. 8, use a screwdriver to turn the adjusting screw (A) Fig. 10 until the blade is square.

LINE-OF-CUT INDICATOR

Line-of-cut indicator slots (A) Fig. 11 are provided at the front of the saw base. The right slot is used to follow a line when making a 0° cut. The left slot is used to follow a line when making a 45° cut. The straight side of the notch indicates the cut line.

USING THE EXHAUST NOZZLE
The exhaust nozzle in the closed position (Fig. 12)
directs the sawdust to the rear of the saw. The	A
exhaust nozzle pointing forward (Fig. 13) directs the
sawdust to the front. To change the position of the

nozzle, push down and turn the nozzle to the new position. An accessory hose assembly is available for connecting the exhaust nozzle in the position directly to a shop-type vacuum cleaner.

Fig. 11

vacuum forward

Fig. 12 Fig. 13

DO NOT direct sawdust toward yourself or others. To avoid injury from flying sawdust, keep the exhaust nozzle either in the forward position or in the closed position. DO NOT insert foreign objects into the

exhaust opening.

INSTALLING THE OPTIONAL RIP GUIDE

1.Insert the rip guide (A) Fig. 14 through the slots (B). Slide the guide in until it extends through the both slots in the sawbase.

2.Place the compression spring on the thumb screw (C) Fig. 14 (supplied with the rip guide), and thread into the hole in the saw base. DO NOT TIGHTEN.

3.Adjust the rip guide for the desired width of cut and tighten the thumb screw.

C
	B
	A
Fig. 14	Fig. 15	Fig. 16

To avoid personal injury and damage to workpiece, extend the rip guide through both slots in the base.

13