10.Refer to Figures 24 and 25, for shim place- ment. If the distance of A is longer than B, shim(s) will need to be placed under corners #1 and #2. If the distance of B is longer than A, shim(s) will need to be placed under cor- ners #3 and #4. Very thin shim stock works well, just make sure they are all the same thickness, and you put an equal number under each of the two corners.
11.Tighten down one bolt a small amount and then move on to each of the others, tighten- ing each down the same amount. Continue to rotate through the bolts, tightening them a little each time until they are all secure.
12.Now recheck the blade to the miter slot at 90¡ and 45¡ by repeating Steps
13.Once you feel you have the miter slot adjust- ed to the blade, recheck all measurements and be sure the table mounting bolts are secure. Repeat Step 10 in Section 4: Assembly, ÒBlade Guard/Splitter.Ó Also, if you ever remove the table in the future, be sure to make note of shim placements and
Blade tilted to 45¡
#1#3
#2#4
Figure 24. 45¡ blade parallelism.
Blade tilted to 45¡
#1#3
#2#4
Figure 25. 45¡ blade parallelism.
G5959/G9957 12" Table Saw |