SECTION 4: ASSEMBLY
Beginning Assembly
! | Disconnect power to the | |||
machine when perform- | ||||
ing | any | maintenance, | ||
| assembly | or | adjust- | |
| ments. Failure to do this | |||
| may | result in | serious | |
| personal injury. |
| ||
Keep loose clothing rolled up and out of the way of machinery and keep hair pulled back.
Wear safety glasses dur- ing the entire assembly process. Failure to com- ply may result in serious personal injury.
Some metal parts may have sharp edges on them after they are formed. Please examine the edges of all metal parts before handling them. Failure to do so could result in injury.
Most of your Model G5959/9957 has been assem- bled at the factory, but some parts must be assembled or installed after delivery. We have organized the assembly process into steps. Please follow along in the order presented here.
TOOLS REQUIRED: You will need a high quality square, a long straightedge, 10mm, 12mm, 14mm open end wrenches and a 3mm Allen¨ wrench.
Extension Wings
Inspect the extension wings for burrs or foreign material that may inhibit assembly. The mating edges of the wings and table must be clean, smooth, and flat. Use a wire brush or file if nec- essary to clean up the edges.
The table and wings represent a very heavy load. DO NOT over- exert yourself while lift- ing or moving the table and wings – get assis- tance.
NOTICE
The right and left wings are not the same. The left wing has two tapped holes on the outside edge, the right has a tapped hole on the front and back edge. If the wings are not installed in their correct location, the fence cannot be attached.
1.Attach the left wing to the table using the three hex head bolts and flat washers pro- vided. Adjust the wing reasonably flush with the table. Do not tighten the bolts.
2.Attach the right wing to the table using the three hex head bolts and flat washers pro- vided. Adjust the wing reasonably flush with the table. Do not tighten the bolts.
3.Align the top of the wing flush with the table top directly above the front bolt, and tighten the front bolt. The front edge of the extension wing should also be flush with the front edge of the table.
4.Raise or lower the rear of the extension wing until the middle of the wing is flush with the table top. Tighten the middle bolt.
G5959/G9957 12" Table Saw |