Table Insert
!
Disconnect power to the machine when perform- ing any maintenance, assembly or adjust- ments. Failure to do this may result in serious personal injury.
The table insert provides access to the blade and arbor when removed. When in place, the insert provides support for materials being cut.
Figure 18. Setscrew on each corner of insert.
1.Disconnect the power cord from the outlet.
2.Ensure that all four setscrews are firmly in contact with the table casting.
3.Using a 6mm hex wrench, raise or lower each of the four setscrews (Figure 18) until the insert is flush with the table top.
4.Now make sure the blade will not come into contact with table insert. Position the blade at 90¡, then raise and lower the blade through its full range of motion. Also, rotate the blade while doing this, making sure that the blade never contacts any part of the table insert. Do the same with the blade in the 45¡ position. Wear leather gloves while rotating the blade to prevent being cut.
5.Be sure to review the ÒBlade Alignment,Ó instructions before operating the saw.
G5959/G9957 12" Table Saw |