Start Up |
| Recommended | ||
|
|
|
| Adjustments |
|
|
| ||
|
|
| ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Loose hair and clothing could get caught in machinery causing seri- ous personal injury. Keep loose clothing rolled up and long hair tied up and away from machinery.
Projectiles thrown from the machine could cause serious eye injury. Wear safety glasses during assembly.
Before starting the machine:
1.Read this manual and make sure you take all safety precautions before operating this machine.
2.Make sure the blade guard and splitter have been correctly installed and are adjusted properly as shown on Pages
3.Make sure that any tools or foreign objects have been removed from the machine.
4.Review Section 3: Circuit Requirements beginning on Page 8 and make sure all wiring is correct.
5.Keep your finger on the STOP button during the entire test run of the machine.
Starting the machine:
Turn the machine on and make sure your hand is on the STOP button in case you need to shut the machine off immediately. The machine should run smoothly with little or no vibration.
For your convenience, the adjustments listed below have been performed at the factory and no further setup is required to operate your machine.
However, because of the many variables involved with shipping, we recommend that you at least check the following adjustments to ensure the best possible results from your new machine.
All of these adjustments are covered in
Recommended adjustment checklist:
¥45û & 90û Stops (Page 39)
¥Blade Parallelism (Page 41)
¥Blade Alignment (Page 42)
|
|
|
|
|
|
|
|
|
| G1023S Series | |
|
|