Preparing the TrimMaster 18™ Finish Nailer for Use
Fasteners
The TrimMaster 18™ Finish Nailer drives Paslode® 18 gauge fasteners designed to be used with the tool. The use of fasteners that do not meet Paslode standards could cause tool damage and will void all warranty claims.
Loading Fasteners
Press the release latch with your thumb and pull the rail cover to the full open position.
Place the 18 gauge finish nails into the rail with the points resting in the bottom of the rail.
Slide the rail cover forward to the locked postion.
➔ | Pull |
| |
| Follower |
In the illustration above, you will see an indicator arrow on the side of the follower. When the indicator arrow is in the reload area, marked on the side of the magazine, you may insert a new strip of nails.
Impulse® and Outdoor Weather
Use the TrimMaster 18™ Finish Nailer outdoors, in dry weather, when the nailer, fuel cell, and battery are between 20°F
HOT WEATHER OPERATION
The TrimMaster18™ Finish Nailer requires cooling of the motor assembly to operate properly. The fan normally provides the necessary air flow to permit continuous operation. Whenever the TrimMaster 18™ Finish Nailer is idle for extended periods, keep the fuel and tool out of direct sunlight and in surroundings where temperatures will not exceed 120°F (49°C). After extended periods of continuous use, it may be necessary to cool the Impulse motor by setting tool aside for
COLD WEATHER OPERATION
Fuel cells at cold temperatures lose the required propellant pressure. Bring the tool, fuel cell, and battery above 20° F
CAUTION
The TrimMaster18™ Finish Nailer should not be used in the rain or where excessive moisture is present. The use of the Impulse Technology under these conditions may result in damage to tool components and cause the tool to malfunction.
12