Impulse IM200 F18 Never Drive Fasteners Into Areas with Concealed Hazards, Keep the Tool Clean

Safety Instructions

12.NEVER DRIVE FASTENERS INTO AREAS WITH CONCEALED HAZARDS.

Always check the area behind the work surface for electrical wiring, gas pipes, water pipes, sewer drains or other potential hazards.

13.ALWAYS MAINTAIN SECURE AND UNOBSTRUCTED FOOTING WHEN ON LADDERS, PLATFORMS OR OTHER HIGH LOCATIONS.

WARNING

Never over-reach, since tool recoil may cause a loss of balance. Always be aware of edges and drop-offs when nailing on rooftops and other high locations. Keep them in full view.

14.ALLOW ONLY QUALIFIED PERSONNEL TO OPERATE THE TRIMMASTER 18™ FINISH NAILER.

15. PROPERLY STORE FUEL CELL.

WARNING

Always store fuel cells where they will not be exposed to an open flame, sparks or temperatures above 120° F (49° C).

16.ALWAYS STORE THE TOOL WITH THE FUEL CELL AND BATTERY REMOVED.

Store the fuel cell in the case with the TrimMaster 18™ Finish Nailer.

17. KEEP THE TOOL CLEAN.

A clean tool is less likely to jam or malfunction.

18.KEEP YOUR HANDS CLEAR OF THE WORK AREA SURFACE.

WARNING

Only persons who have read and fully understand all tool operation safety and maintenance instructions should be allowed to operate the tool.

WARNING

A fastener may exit at an angle unexpectedly and cause injury.

Battery Disposal:

The Paslode batteries contains cadmium and must be recycled or disposed of properly. It is illegal in some areas to place a nickel-cadmium battery into the trash or solid waste stream. You may contact your local recycling center for information on where to return the spent battery or call 1-800-822-8837 for information on Ni-Cd battery recycling in your area.

6