Battery and Charging System
Battery and Charging System
The Paslode Cordless tools come with a recharge- able battery and its own charging system. This charging system is the only one that will work with the Pasldoe batteries (either round or oval ). The first step in preparing a new tool for operation is to fully charge the battery. New batteries are shipped discharged and must be charged prior to first use. Batteries will take 5 minutes to 2 hours (time will be dependant on the amount of discharge of the battery) to recharge.
Important Charging Notes
Warning
CHEMICAL/EXPLOSION HAZARD
Read ALL instructions be- fore charging or using bat- tery. Failure to follow ALL instructions may result in fire, severe burns, or re- lease of toxic materials.
Battery Disposal:
The Paslode batteries contain cadmium and must be recycled or disposed of properly. It is illegal in some areas to place a
Wall Mount Unit | REAR VIEW OF | |
CHARGER BASE | ||
| ||
| Plug Receptacle | |
| Charger Base | |
| Plug | |
THE PASLODE BATTERY CHARGING SYSTEM | ||
Charging Instructions
1.Remove wall mount unit with the orange label from the tool case and plug into a 120V AC outlet. Set orange charger on a stable surface and insert wall mount unit’s plug into plug receptacle on the back of the charger (see picture). A green light indicates power is on and charger circuit is ready.
2.Remove the battery from tool or case and insert terminals down into charger. The red light will come on indicating that the battery is charging and the green light will go out.
NOTE
If battery is completely discharged, the red light and the green light may alternate back and forth for up to 20 minutes. This safety feature slowly recharges the battery until it is ready to accept the full charging current. If the red and green lights continue to alternate after 20 minutes, replace the battery.
3.After charging is complete, the red light will go out and the green light will come on, indicating that the battery is fully charged. The charger will keep the battery at full charge until it is removed.
4.Unplug the wall mount unit from the charger and remove the wall mount unit from the 120V AC outlet.
CHARGING TIMES:
First charge (new battery) | 2 hours |
Discharged Battery | 5 minutes to 2 hours |
CHARGING DON'TS:
1.Do not charge battery outdoors or in temperatures below 40°F (5°C).
2.Do not allow metal objects to come in contact with battery terminals.
3.Do not puncture or attempt to open battery case or cells.
4.Do not store battery where it will be subjected to temperatures above 120°F (49°C).
5.Do not incinerate battery.
6.Do not use a defective battery charger, one that
7.Do not immerse the battery in water.
PaslodeCharging System Accessories:
Battery Charger Kit - Part No. 900200
Wall Mount Transformer* - Part No. 900477
Battery Charger Base* - Part No. 900476
Automotive Adapter* - Part No. 900507
*Cannot use with previous (gray in color) charging system components.
7