Troubleshooting
Problem |
| Possible Causes |
| Likely Solutions | |
Air leaking in Cylinder Cap (8). | 1. | Loose Screw (6). | 1. | Tighten and recheck. | |
2. | Gasket (9) is cracked or worn. | 2. | Replace Gasket. | ||
|
|
|
|
| |
| 1. | Tool is too dry. | 1. | Add about 3 drops of pneumatic | |
Lack of power. Slow to cycle. |
|
|
| tool oil into the Air Coupler (95). | |
2. | Air pressure too low. | 2. | Check to make sure regulator on | ||
Low power when shooting and | |||||
returning. |
|
|
| air compressor is set between | |
|
|
| 70 PSI and 120 PSI. | ||
|
|
|
| ||
| 3. | Exhaust blocked. | 3. | Clean exhaust channel. | |
|
|
|
|
| |
| 1. | Damaged Torsion Spring (89). | 1. | Replace Spring. | |
Not shooting fasteners or only | 2. | Wrong size of fasteners. | 2. | Use 2” to | |
intermittent feeding. | 3. | Magazine (79) or Joint Plate | 3. | Clean Magazine and Plate. | |
|
| (86) is dirty. |
|
| |
| 1. | Driver channel is worn. | 1. | Replace Driver Channel (30) | |
|
|
|
| and/or Driver (20). | |
| 2. | Feeder Shoe (73) is broken or | 2. | Replace Feeder Shoe. | |
|
| worn. |
|
| |
Fastener is jammed in tool. | 3. | Bent fasteners. | 3. | Remove bent fasteners. | |
|
|
|
| Replace with new fasteners. | |
| 4. | Nailer angle is not properly | 4. | Check all 3 angle adjustments | |
|
| adjusted for the correct angle |
| as outlined on page 10. | |
|
| nail clip. |
|
|
Follow all safety precautions whenever diagnosing or servicing the tool. Disconnect air supply before service.
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLY DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER OR DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT, OR THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR DISTRIBUTOR EXPRESSLY STATES THATALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS, AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO.
REV 08j
SKU 98751 | For technical questions, please call | Page 15 |