Global Machinery Company LS8B instruction manual Maintenance, Power cord maintenance

Page 15

Maintenance

Note. Always wear eye protection when cleaning the tool.

WARNING. Always ensure that the saw is switched off and unplugged from the power supply before carrying out any maintenance or cleaning.

1.Keep the tool’s air vents unclogged and clean at all times.

2.Remove dust and dirt regularly. Cleaning is best done with a brush or a rag.

3.Open the housing doors and remove chips and saw dust with a brush or vacuum cleaner.

4.Re-lubricate all moving parts at regular intervals.

5.Never use caustic agents to clean plastic parts.

Caution. Do not use cleaning agents to clean the plastic parts of the saw. A mild detergent on a damp cloth is recommended. Water must never come into contact with the saw.

Power cord maintenance

If the supply cord needs replacing, the task must be carried out by the manufacturer, the manufacturer's agent, or an authorised service centre in order to avoid a safety hazard.

General inspection

Regularly check that all the fixing screws are tight. They may vibrate loose over time.

15

Image 15
Contents Redeye Contents Safety rules for laser lights SpecificationsLaser Light Laser Radiation Safety instructionsAdditional safety rules for band saws Accessories UnpackingSupport the work properly Saw blade Know your productWorkpiece maximum distance 3mm AssemblyUpper blade guide adjustment MountingTighten the guide pin locking screws Lower blade guide adjustmentPress the guide pins together against the band saw blade Tighten the thrust bearing locking screwTouch the saw blade Housing doorsAdjusting the rip fence Upper housing doorAdjusting the bevel angle Adjusting the saw blade tensionAdjusting the blade tracking Turning on and off Installing and removing band saw bladesTighten the table locking knob 20 and table setting lever Dust collector connectionRemove the rip fence 13 from the table Open both housing doorsIf required, adjust the saw blade tracking OperationUsing the Redeye laser line generator Changing the batteriesDo not mix old and new batteries Power cord maintenance MaintenanceSave this Manual for future reference