Global Machinery Company LS8B instruction manual Save this Manual for future reference

Page 16

Carefully read the entire Instruction Manual before using this product.

Before returning this product for a Warranty Claim or any other reason Please Call 1300 880 001 (Australia) or 0800 445 721 (New Zealand)

When you make your call, please have the following information at hand:

GMC Product Type GMC Product Code

A GMC Service Engineer will take your call and, in most cases, will be able to solve your problem over the phone.

You are welcome to use this phone-in service to make suggestions or give comments about any GMC product.

With continuing product development changes may have occurred which render the product received slightly different to that shown in this instruction manual. The manufacturer reserves the right to change specifications without notice. Note: Specifications may differ from country to country.

The GMC 777 Helpline operates from 7am to 7pm, 7 days a week (EST). This allows you to contact GMC directly with any queries and technical questions you have regarding

our products.

45–55 South Centre Road

Melbourne Airport

Victoria, Australia 3045

Tel: (03) 8346 1100 Fax: (03) 8346 1200

Save this Manual for future reference.

Image 16
Contents Redeye Contents Specifications Safety rules for laser lightsSafety instructions Laser Light Laser RadiationAdditional safety rules for band saws Unpacking AccessoriesSupport the work properly Know your product Saw bladeAssembly Upper blade guide adjustmentMounting Workpiece maximum distance 3mmLower blade guide adjustment Press the guide pins together against the band saw bladeTighten the thrust bearing locking screw Tighten the guide pin locking screwsHousing doors Adjusting the rip fenceUpper housing door Touch the saw bladeAdjusting the saw blade tension Adjusting the bevel angleAdjusting the blade tracking Installing and removing band saw blades Tighten the table locking knob 20 and table setting leverDust collector connection Turning on and offOpen both housing doors If required, adjust the saw blade trackingOperation Remove the rip fence 13 from the tableChanging the batteries Using the Redeye laser line generatorDo not mix old and new batteries Maintenance Power cord maintenanceSave this Manual for future reference