•Support the work properly.
•Never reach over the blade to remove waste or off cuts.
•Do not attempt to free a jammed blade before first switching off the machine.
•Do not slow or stop a blade with a piece of wood. Let the blade come to rest naturally.
•If you are interrupted when operating the saw, complete the process and switch off before looking up.
•Periodically check that all nuts, bolts and other fixings are properly tightened.
•Do not store materials or equipment above a machine in such a way that they could fall into it.
•Ensure that your work is always on the table. Never make a cut with the work off the table.
•Wear goggles
•Wear hearing protection
•Wear a breathing mask
Unpacking
Due to modern mass production techniques, it is unlikely that your GMC Power Tool is faulty or that a part is missing. If you find anything wrong, do not operate the tool until the parts have been replaced or the fault has been rectified. Failure to do so could result in serious personal injury.
Accessories
The GMC Laser Band Saw is supplied with the following accessories:
•Work table
•1400mm x 6.35mm x 0.35mm band saw blade
– 6TPI (a).
•Rip fence (b).
•3 x 16mm x M6 screws with matching washers and nuts (c).
•2 x 20mm x M6 screws with matching thumb nuts and U shape bracket (d).
•3mm Allen key & 4mm Allen key (e).
•Open ended spanner – 13mm x 10mm (f).
•2 x AA batteries
a.b.
c.d.
e.f.
6