Global Machinery Company LS8B instruction manual Specifications, Safety rules for laser lights

Page 3

Dear Customer

If you require any help with your product, whether it is a Warranty claim, spare part or user information, please phone our Help Line for an immediate response. Phone 1300 880 001 in Australia or 0800 445 721 in New Zealand.

Introduction

Your new GMC power tool will more than satisfy your expectations. It has been manufactured under stringent GMC Quality Standards to meet superior performance criteria.

You will find your new tool easy and safe to operate, and, with proper care, it will give you many years of dependable service.

Caution. Carefully read through this entire Instruction Manual before using your new GMC Power Tool. Take special care to heed the Cautions and Warnings.

Your GMC power tool has many features that will make your job faster and easier. Safety, performance, and dependability have been given top priority in the development of this tool, making it easy to maintain and operate.

Environmental protection

Recycle unwanted materials instead of disposing of them as waste. All tools, hoses and packaging should be sorted, taken to the local recycling centre and disposed of in an environmentally safe way.

Description of symbols

The rating plate on your tool may show symbols. These represent important information about the product or instructions on its use.

Wear hearing protection.

Wear eye protection.

Wear breathing protection.

Conforms to relevant standards for electromagnetic compatibility.

Specifications

Nominal voltage:

230–240Vac ~ 50Hz

Input power:

250W

No load speed:

1400 RPM

Table size:

300mm x 300mm

Throat length:

200mm

Bevel angle:

0° to 45°

Cutting capacity:

80mm

Saw blade length:

1400mm

Saw blade width*:

3–12.7mm

Teeth per inch:

6 TPI

* Supplied with a 1400 x 0.35 x 6.35mm general purpose blade

Safety rules for laser lights

The laser light/laser radiation used in the GMC REDEYE® system is Class 1 with maximum 0.39mW and 650nm wavelengths. These lasers do not normally present an optical hazard, although staring at the beam may cause flash blindness.

Warning. Do not stare directly at the laser beam. A hazard may exist if you deliberately stare into the beam, please observe all safety rules as follows;

The laser shall be used and maintained in accordance with the manufacturer’s instructions.

3

Image 3
Contents Redeye Contents Safety rules for laser lights SpecificationsLaser Light Laser Radiation Safety instructionsAdditional safety rules for band saws Accessories UnpackingSupport the work properly Saw blade Know your productWorkpiece maximum distance 3mm AssemblyUpper blade guide adjustment MountingTighten the guide pin locking screws Lower blade guide adjustmentPress the guide pins together against the band saw blade Tighten the thrust bearing locking screwTouch the saw blade Housing doorsAdjusting the rip fence Upper housing doorAdjusting the bevel angle Adjusting the saw blade tensionAdjusting the blade tracking Turning on and off Installing and removing band saw bladesTighten the table locking knob 20 and table setting lever Dust collector connectionRemove the rip fence 13 from the table Open both housing doorsIf required, adjust the saw blade tracking OperationUsing the Redeye laser line generator Changing the batteriesDo not mix old and new batteries Power cord maintenance MaintenanceSave this Manual for future reference