OPERATIONS
Loading
Use nails meeting the specifications listed for your nailer on Page 4 of this manual.
To load nails in your nailer:
1.DISCONNECT NAILER FROM THE AIR SUPPLY!
Point the nailer away from you and others when connecting the air supply. The nailer can cycle and discharge a nail when the air supply is connected. Ignoring this warning may result in serious personal injury.
2.Slide the magazine pusher to the rear of the magazine as shown in Figure 3.
Pusher
Figure 3. Sliding the pusher to the rear of
the magazine.
3.Lift the pusher upward toward the nailer body until the pusher latches into the lock notch as shown in Figure 4.
Lock Notch
Pusher
Figure 4. Lifting the pusher into the lock
notch.
4.With the pusher locked at the rear of the magazine, insert a strip of nails into the magazine as shown in Figure 5.
Nail Strip
Figure 5. Loading a nail strip into the
magazine.
5.Lift the pusher out of the lock notch and guide it forward to push the nail strip to the nose of the nailer. (Do not let it snap.)
H7945/H7946/H7995 26° Angle Nailer |