Unloading Nails
To remove unused nails:
1.DISCONNECT NAILER FROM THE AIR SUPPLY!
2.Point the nailer away from you and all bystanders.
3.Slide the pusher to the rear of the mag- azine and latch it into the lock notch.
4.Move the nails to the rear of the maga- zine and remove them by hand.
Rotating the Exhaust
Cover
The exhaust cover rotates as needed to direct the exhaust away from you.
To rotate the exhaust cover:
1.Use the 4mm hex wrench to loosen the exhaust cover cap screw as shown in Figure 6.
Exhaust
Cap Screw
Figure 6. Loosening the exhaust cap
screw.
2.Rotate the exhaust cover by hand to aim the exhaust port in the desired direction.
3.Tighten the exhaust cover cap screw.
H7945/H7946/H7995 26° Angle Nailer |