Grizzly H7995, H7946 instruction manual Cleaning & Lubricating, CleaningLubricating

Page 15

CLEANING & LUBRICATING

CleaningLubricating

Use an automotive grade solvent such as Sprayway C-60®(G2544 in the Grizzly catalog) to clean the nose assembly of the nailer. Always be sure that the nailer is dry before using it again.

Do not allow dust, chips, or sand into the air connectors or into the body of the nail- er; this may result in leaks and damage to the nailer and the air couplings.

Never use gasoline to clean this tool. Use extreme caution when using any solvent cleaner. Always clean the tool in a well-ventilated area and never if sparks or open flames are present. Remember that electrical machinery can produce sparks during normal operation. Ignoring this warning can cause serious personal injury or even death!

Special pneumatic tool oil has been included with your new Grizzly nailer to help maintain its useful life. Place two to six drops of oil in the nailer air inlet (as shown in Figure 10) every 2 hours of continuous use.

Wipe off any excess oil near the nailer exhaust to avoid dust build-up. When the oil that was included with your nailer has been completely used, replace with Grizzly Model G2820 Pneumatic Tool Oil.

An efficient alternative to oiling your tool by hand is to install a lubricator in your air compressor line. If your air compressor line already has a lubricator, then regular lubrication of your nailer will not be neces- sary. Just make sure there is always oil in the lubricator.

Figure 10. Lubricating the nailer at the

air inlet.

H7945/H7946/H7995 26° Angle Nailer

-13-

Page 14 Page 16
Image 15
Page 14 Page 16
Contents Model H7945/H7946/H7995 Mation about proper operation of the equipment SafetySafety Instructions For Pneumatic Tools Before Operating This EquipmentAlways Wear Ansi Approved Hearing Protection Additional Safety Instructions for Nailers H7945/H7946/H7995 26 Angle Nailer Introduction Foreword Model H7995 SpecificationsModel H7945 Specifications Model H7946 SpecificationsHex Wrenches 3, 4mm Each SetupUnpackingInventory Model H7945/H7946/H7995 InventoryCompressed Air System To verify that the safety nose is working correctly Testing the Safety Nose MechanismOperations LoadingTo load nails in your nailer To rotate the exhaust cover Unloading NailsRotating the Exhaust Cover To remove unused nailsTo operate your nailer Using the NailerAdjusting Depth To adjust the nail depthTo clear a jammed nail from the dis- charge area To replace a piston and O-rings Replacing Pistons/O-RingsCleaningLubricating Cleaning & LubricatingH7945 Parts Breakdown Description H7945 Parts ListH7946 Parts Breakdown Description H7946 Parts ListH7995 Parts Breakdown H7995 Parts List Symptom Possible Cause Solution TroubleshootingWarranty and Returns Page Warranty Card BOX BELLINGHAM, WA Name Street CityStateZip
Top Page Image Contents