Grizzly H7946, H7995 instruction manual Using the Nailer, To operate your nailer

Page 12

Using the Nailer

Read the manual before operation. Become familiar with these nailers, their safety instructions, and opera- tion before beginning any work. Serious personal injury may result if safety or operational information is not understood or followed.

Before you operate your nailer, place five to six drops of air tool oil into the quick connect fitting where the nailer connects to the air supply.

To operate your nailer:

1.Connect the air supply to the quick connect fitting on your nailer.

2.To test for proper nail penetration, hold the nailer perpendicular to the surface of a piece of clean scrap wood that is thick enough for the length of nails you have loaded.

3.Depress the safety nose mechanism against your workpiece.

4.Before pulling the trigger, make sure your free hand and other body parts are positioned out of the way of a potential path of a nail in case of deflection (illustrated below in Figure 7).

Figure 7. Example of nail deflection.

Note: Deflection is caused when grain irregularities, knots or foreign objects inside the wood cause the nail to change its path, resulting in the nail puncturing the surface of the workpiece.

Besides damaging your workpiece, deflection can cause injury if your free hand is securing the workpiece in the location that the nail deflects.

5.Pull the trigger.

If the nail penetrates the wood to the depth you want, continue with your intended operations.

If the nail either went too far or not far enough, adjust the depth of fire by following the procedures listed on Page 11.

-10-

H7945/H7946/H7995 26° Angle Nailer

Image 12
Contents Model H7945/H7946/H7995 Safety Safety Instructions For Pneumatic ToolsBefore Operating This Equipment Mation about proper operation of the equipmentAlways Wear Ansi Approved Hearing Protection Additional Safety Instructions for Nailers H7945/H7946/H7995 26 Angle Nailer Foreword Model H7995 Specifications Model H7945 SpecificationsModel H7946 Specifications IntroductionSetup UnpackingInventoryModel H7945/H7946/H7995 Inventory Hex Wrenches 3, 4mm EachCompressed Air System Testing the Safety Nose Mechanism To verify that the safety nose is working correctlyOperations LoadingTo load nails in your nailer Unloading Nails Rotating the Exhaust CoverTo remove unused nails To rotate the exhaust coverUsing the Nailer To operate your nailerAdjusting Depth To adjust the nail depthTo clear a jammed nail from the dis- charge area Replacing Pistons/O-Rings To replace a piston and O-ringsCleaning & Lubricating CleaningLubricatingH7945 Parts Breakdown H7945 Parts List DescriptionH7946 Parts Breakdown H7946 Parts List DescriptionH7995 Parts Breakdown H7995 Parts List Troubleshooting Symptom Possible Cause SolutionWarranty and Returns Page Warranty Card Name Street CityStateZip BOX BELLINGHAM, WA