Grizzly H7946, H7995 Before Operating This Equipment, Safety Instructions For Pneumatic Tools

Page 2

SAFETY

For Your Own Safety Read Instruction Manual

Before Operating This Equipment

The purpose of safety symbols is to attract your attention to possible hazard- ous conditions. This manual uses a series of symbols and signal words which are intended to convey the level of importance of the safety messages. The progression of symbols is described below. Remember that safety messages by themselves do not eliminate danger and are not a substitute for proper accident prevention measures.

Indicates an imminently hazardous situation which, if not avoided, WILL result in death or serious injury.

 

Indicates a potentially hazardous situation which, if

 

not avoided, COULD result in death or serious injury.

 

Indicates a potentially hazardous situation which, if

 

not avoided, MAY result in minor or moderate injury.

 

It may also be used to alert against unsafe practices.

NOTICE

This symbol is used to alert the user to useful infor-

mation about proper operation of the equipment.

Safety Instructions For Pneumatic Tools

1.KEEP ALL SAFETY DEVICES IN PLACE and in working order.

2.REMOVE ADJUSTING KEYS AND WRENCHES. Form habit of check- ing to see that keys and adjusting wrenches are removed from tool before operation.

3.KEEP WORK AREA CLEAN. Cluttered areas and benches invite accidents.

4.DO NOT USE IN DANGEROUS ENVIRONMENT. Do not use pneu- matic tools in damp or wet loca- tions, or where any flammable or noxious fumes may exist. Keep work area well lighted.

5.KEEP CHILDREN AND VISITORS AWAY. All children and visitors should be kept at a safe distance from work area.

6.MAKE WORKSHOP CHILD PROOF by locking your shop and shutting off air valves.

7.DO NOT FORCE TOOL. It will do the job better and safer at the rate for which it was designed.

8.USE THE RIGHT TOOL. Do not force tool or attachment to do a job for which it was not designed.

9.DO NOT USE UNDER THE INFLUENCE OF DRUGS OR ALCOHOL.

Image 2
Contents Model H7945/H7946/H7995 Before Operating This Equipment SafetySafety Instructions For Pneumatic Tools Mation about proper operation of the equipmentAlways Wear Ansi Approved Hearing Protection Additional Safety Instructions for Nailers H7945/H7946/H7995 26 Angle Nailer Model H7946 Specifications Foreword Model H7995 SpecificationsModel H7945 Specifications IntroductionModel H7945/H7946/H7995 Inventory SetupUnpackingInventory Hex Wrenches 3, 4mm EachCompressed Air System Testing the Safety Nose Mechanism To verify that the safety nose is working correctlyTo load nails in your nailer OperationsLoading To remove unused nails Unloading NailsRotating the Exhaust Cover To rotate the exhaust coverUsing the Nailer To operate your nailerTo clear a jammed nail from the dis- charge area Adjusting DepthTo adjust the nail depth Replacing Pistons/O-Rings To replace a piston and O-ringsCleaning & Lubricating CleaningLubricatingH7945 Parts Breakdown H7945 Parts List DescriptionH7946 Parts Breakdown H7946 Parts List DescriptionH7995 Parts Breakdown H7995 Parts List Troubleshooting Symptom Possible Cause SolutionWarranty and Returns Page Warranty Card Name Street CityStateZip BOX BELLINGHAM, WA