Adjusting Depth |
| Clearing Jammed |
|
| Nails |
| ||
|
|
|
Adjusting the depth of nail penetration is done by turning the adjustment knob locat- ed near the trigger as shown in Figure 8.
Depth Adjustment
Knob
Figure 8. Depth adjustment knob.
To adjust the nail depth:
1.DISCONNECT NAILER FROM THE AIR SUPPLY AND POINT THE NAILER IN A SAFE DIRECTION!
2.Turn the depth adjustment knob to increase or decrease nail penetration:
—If you want to increase the nail depth, then turn the adjusting knob counter clockwise.
—If you want to decrease the nail depth, then turn the adjusting knob clockwise.
3.Connect the nailer to the air supply, test the nail depth, and repeat this entire procedure if necessary until the nail depth is satisfactory.
A jammed nail must be cleared before the nailer is used again.
To clear a jammed nail from the dis- charge area:
1.DISCONNECT NAILER FROM THE AIR SUPPLY!
2.Remove all nails from the magazine. (See Unloading Nails on Page 9.)
3. Use a pair of pliers to grab the jammed nail and pull it from the nose as shown in Figure 9.
Jammed Nail 
Figure 9. Using pliers to remove a
jammed nail.
Note: If you cannot remove the jammed nail in this way, then disassemble the nailer's nose assembly to gain full access to the nail, remove it and reas- semble. Refer to the parts breakdown drawing included in the back pages of this manual for guidance during this procedure.
4.Throw the damaged nail away and insert a new strip of nails. DO NOT use dirty or damaged nails!
H7945/H7946/H7995 26° Angle Nailer |