Woodstock W1815 manual Assembly, To assemble the cabinet and mount the sander, do these steps

Page 16

Model W1815 (Mfg. Since 10/10)

Assembly

Before beginning assembly, refer to the inventory list and group all fasteners with their intended components. Doing this will make assembly easier. When assembling this machine, tighten fasteners using hand tools only. Be careful if using air or electric impact tools to assemble this machine because fasteners can easily be over- tightened, causing them to dig into the paint, and strip threads

To assemble the cabinet and mount the sander, do these steps:

1.Fasten the left and right panels to the rear panel, as shown in Figure 5, using (4) 5⁄16"-18 x 3⁄4" carriage bolts and (4) 5⁄16"-18 flange nuts.

SETUP

2.Fasten the upper and lower shelves, as shown in Figure 6, using (8) M6-1 x 12 flange bolts.

3.Fasten the panel and door assembly to the left and right panels, as shown in Figure 7, using (4) 5⁄16"-18 x 3⁄4" carriage bolts and (4) 5⁄16"-18 flange nuts.

Figure 5. Side and rear panel installation.

Figure 6. Shelf installation.

Figure 7. Door w/panel installation.

-14-

Image 16

Contents OWNERS MANUAL Page Contents Woodstock Technical Support IntroductionMachine Description B68=C HE886IDCH Model W1815 Mfg. Since 10/10 Controls and Features IdentificationSAFETYJ8=KP ZXlj\XdX\kfk\dXZ`e\ip%Safety Additional Safety for Disc Sanders 220V/240V, 60 Hz, Single-Phase ElectricalCircuit Requirements AmpsGrounding Requirements Extension Cords Setup Unpacking Inventory Main Inventory Figure QtyMachine Placement Weight LoadCleaning Machine To remove the rust preventative coating, do these stepsAssembly To assemble the cabinet and mount the sander, do these stepsSander installation Test Run To test run the machineOperations Operation OverviewAttaching Sandpaper To attach sandpaper, do these stepsDisc Sanding To use the sanding disc, do these stepsAccessories Maintenance CleaningSchedule LubricationService GeneralTable Gap & Parallelism Tools NeededMiter Gauge Calibration To calibrate the miter gauge, do these stepsTable Tilt Calibration To calibrate the table tilt, do these stepsElectrical Safety Instructions Wiring Diagram Color KEYWiring Diagram StopTroubleshooting Problem Possible CauseInstall a coarse grit sandpaper, or strip coating off Parts MainMachine Labels DescriptionModel W1815 Mfg. Since 10/10 Place Stamp Here Warranty =\FjVainBVXcZhVcYIddah