Woodstock W1815 manual Machine Labels, Description

Page 32

Model W1815 (Mfg. Since 10/10)

Machine Labels

Safety labels warn about machine hazards and how to prevent machine damage or injury. The owner of this machine MUST maintain the original location and readability of all labels on this machine. If any label is removed or becomes unreadable, REPLACE that label before allowing the machine to enter service again. Contact Woodstock International, Inc. at (360) 734-3482 or www. shopfoxtools.com to order new labels.

105

104

103	106

102	107

101

108

109

110

PARTS

REF	PART #	DESCRIPTION		REF	PART #	DESCRIPTION
101	X1815101	MACHINE ID LABEL		106	X1815106	ABRASION HAZARD LABEL
102	X1815102	MODEL NUMBER LABEL		107	XLABEL-07B	DISCONNECT WARNING LABEL
103	XLABEL-12	READ MANUAL LABEL		108	D3377	SHOP FOX NAMEPLATE
104	XLABEL-04	ELECTRICITY LABEL		109	XPPAINT-1	SF WHITE TOUCH-UP PAINT
105	X1815105	DISC ROTATION LABEL		110	X1815110	STAND BLACK STRIPE LABEL

-30-

Image 32

Contents OWNERS MANUAL Page Contents Machine Description IntroductionWoodstock Technical Support B68=C HE886IDCH Model W1815 Mfg. Since 10/10 Controls and Features IdentificationSAFETYJ8=KP ZXlj\XdX\kfk\dXZ`e\ip%Safety Additional Safety for Disc Sanders 220V/240V, 60 Hz, Single-Phase ElectricalCircuit Requirements AmpsGrounding Requirements Extension CordsSetup UnpackingInventory Main Inventory Figure QtyMachine Placement Weight LoadCleaning Machine To remove the rust preventative coating, do these stepsAssembly To assemble the cabinet and mount the sander, do these stepsSander installation Test Run To test run the machineOperations Operation OverviewAttaching Sandpaper To attach sandpaper, do these stepsDisc Sanding To use the sanding disc, do these stepsAccessories Maintenance CleaningSchedule LubricationService GeneralTable Gap & Parallelism Tools NeededMiter Gauge Calibration To calibrate the miter gauge, do these stepsTable Tilt Calibration To calibrate the table tilt, do these stepsElectrical Safety Instructions Wiring Diagram Color KEYWiring Diagram Stop Troubleshooting Problem Possible CauseInstall a coarse grit sandpaper, or strip coating off Parts MainMachine Labels DescriptionModel W1815 Mfg. Since 10/10 Place Stamp Here Warranty =\FjVainBVXcZhVcYIddah