Woodstock W1815 manual Disc Sanding, To use the sanding disc, do these steps

Page 21

Model W1815 (Mfg. Since 10/10)

Disc Sanding

The Model W1815 uses dual-axis miter slot design for increased versatility of workpiece control.

Always keep the workpiece on the side of the wheel that is rotating down toward the table. This will keep the workpiece from flying out of your hands if kickback occurs.

To reduce the risk of your fingers getting trapped between the work table and sanding disc, make sure the table is approximately 3⁄16" away from the sanding disc.

To use the sanding disc, do these steps:

1.DISCONNECT SANDER FROM POWER!

2.Set the angle of the table and miter gauge for your operation.

3.Connect the sander to power, turn it ON, and allow it to reach full speed.

4.Place the workpiece on the work table and firmly against the miter gauge.

5.With light, but firm pressure, push the workpieece into the down-spin side of the rotating disc. See Figures 13—16for examples of disc sanding.

Note: To prevent burning the workpiece and overloading the sanding disc, move the workpiece slowly back and forth from the left side of the sanding disc to the center.

Figure 13. Example of Y-axis sanding.

Figure 14. Example of X-axis sanding.

Figure 15. Angle sanding.

OPERATIONS

Figure 16. Sanding with table angled.

-19-

Page 20 Page 22
Image 21
Page 20 Page 22
Contents OWNERS MANUAL Page Contents Introduction Woodstock Technical SupportMachine Description B68=C HE886IDCH Model W1815 Mfg. Since 10/10 Identification Controls and FeaturesZXlj\XdX\kfk\dXZ`e\ip% SAFETYJ8=KPSafety Additional Safety for Disc Sanders Electrical 220V/240V, 60 Hz, Single-PhaseCircuit Requirements AmpsExtension Cords Grounding RequirementsUnpacking SetupInventory Main Inventory Figure QtyWeight Load Machine PlacementTo remove the rust preventative coating, do these steps Cleaning MachineTo assemble the cabinet and mount the sander, do these steps AssemblySander installation To test run the machine Test RunOperation Overview OperationsTo attach sandpaper, do these steps Attaching SandpaperTo use the sanding disc, do these steps Disc SandingAccessories Cleaning MaintenanceSchedule LubricationGeneral ServiceTable Gap & Parallelism Tools NeededTo calibrate the miter gauge, do these steps Miter Gauge CalibrationTo calibrate the table tilt, do these steps Table Tilt CalibrationWiring Diagram Color KEY Electrical Safety InstructionsStop Wiring DiagramProblem Possible Cause TroubleshootingInstall a coarse grit sandpaper, or strip coating off Main PartsDescription Machine LabelsModel W1815 Mfg. Since 10/10 Place Stamp Here Warranty =\FjVainBVXcZhVcYIddah
Top Page Image Contents