Model W1815 (Mfg. Since 10/10)
4. Invert the cabinet, thread the (4) hex nuts onto the feet, and install the feet into the base, as shown in Figure 8.
5. Adjust the feet to the same height, tighten the hex nuts against the cabinet base to lock the feet in place, then return the cabinet right side up.
Figure 8. Foot installation.
6.With the help of another person, place the sanding unit onto the top of the cabinet, as shown in Figure 9, and fasten it to the cabinet using (4) M8-1.25 x 45 hex bolts and (4) 5⁄16" flat washers.
7.Make sure that all tools and objects used for setup are cleared away from the machine.
The machine is now fully assembled, and ready for the test run procedure.
SETUP |