Woodstock W1717 instruction manual Mounting Sander, Keep Sander Unplugged

Page 14

Mounting Sander

Mounting the sander to the stand will require the help of an assistant. Secure the sander to the stand using the supplied M8-1.25 x 40 hex bolts, 8mm washers and 8mm flat washers.

The Model W1717 is a heavy machine at 56 lbs. Use assistance when lifting or moving the machine.

To mount the sander, do these steps:

1.KEEP SANDER UNPLUGGED!

2.Position the sander on the stand.

3.Align the holes in the sander with the holes pre-drilled in the stand.

4. Secure the sander to the stand as shown in Figure 6.

5. Tighten down all the carriage bolts in the stand.

UNPLUG sander before you do any assembly! Otherwise, serious per- sonal injury to you or oth- ers may occur!

Figure 6. Mounting the sander.

-12-

Image 14

Contents Horizontal/Vertical Sander Page Contents About Your New Sander Woodstock Service and SupportIntroduction Warranty and Returns SpecificationsSafety Standard Safety Instructions#16 #14 11-12 13-16 #12 17-20 #10 21-30 Know Your Machine Safety Instructions for Your Sander Grounding 110V OperationExtension Cords Inventory AssemblyUnpacking Dust Collection Initial CleaningShop Preparation Stand Assembly To assemble the work stand, do these stepsMounting Sander Keep Sander UnpluggedAdjustments Belt TrackingScale Pointer Belt tilt locking knob Scale PointerRoller Adjustment Loosen the four motor mounting bolts FigureOperations Test RunPower Switch Belt SelectionHeight adjustment knob 1 Work Stop Bar Edge and End SandingHeight adjustment knobs Contour SandingFlat Sanding Bevel SandingChanging Sanding Belt Removing belt guard Belt RotationLubrication MaintenanceGeneral Sanding BeltPage Parts Description Troubleshooting Sanding Warranty Card Woodstock INTERNATIONAL, INC