Flat Sanding
Flat sanding operations can be performed with the sanding belt tilted to 180˚.
To start flat sanding operations, do these steps:
1.UNPLUG THE SANDER!
2.Loosen the belt tilting lock knob shown in and rotate the sanding belt to the 180˚ mark on the scale (FIgure 20).
3.Tighten the lock knob.
4.Make sure the work stop is installed to pre- vent the workpiece from running off the sanding belt.
5.Plug the sander into the power supply.
6.Start the sander.
7.Hold the workpiece firmly in both hands as shown in Figure 21.
Bevel Sanding
Bevel sanding operations can be done when the belt is tilted to a specific angle.
To start a bevel sanding operations, do these steps:
1.UNPLUG THE SANDER!
2.Loosen the belt tilting lock knob and rotate the sanding belt to the desired angle, then tighten the lock knob.
3.Plug the sander into the power source.
4.Start the sander.
5.Firmly hold the workpiece against the table and feed it into the sander as shown in
FIgure 23.