Scale Pointer
The scale pointer on the sander indicates the tilt angle of the sanding belt relative to the edge sanding table. It has been set at the factory but throughout the life of your machine, you may need to make adjustments.
To adjust the scale pointer, do these steps:
1.UNPLUG THE SANDER!
2.Loosen the belt tilting lock knob shown in FIgure 10 and rotate the sanding belt so it is perpendicular with the edge sanding table.
3.Place a machinist square on the edge sand- ing table and against the sanding belt to check for squareness.
4.Lock the belt tilting knob when the belt is perpendicular to the table.
5.Adjust the scale pointer so it indicates 90˚(Figure 11).
UNPLUG the power cord when making any adjust- ments during operation! Otherwise, serious per- sonal injury to you or oth- ers may occur!
Locking Knob