Roller Adjustment
The motor mounting plate can be adjusted to correctly position the main roller in relation to the platen.
To adjust the main roller position, do these steps:
1.UNPLUG THE SANDER!
2.Loosen the four motor mounting bolts (Figure 12).
3.Remove the sanding belt.
4.Place a straightedge against the platen and check the roller clearance along the top and bottom. The roller should be 1⁄8" behind the platen. Figure 13 shows a top view of the proper clearance.
5.Tighten the motor mounting bolts when the proper clearance has been achieved.
Figure 12. Motor mounting bolts (only 2 shown).
Roller |
Platen |
1⁄8" |