Edge and End
Sanding
Edge and end sanding operations should be per- formed on the edge sanding table. These opera- tions are designed to sand flat edges, smooth sharp corners and remove stock.
To start an edge or end sanding operations, do these steps:
UNPLUG the power cord when making any adjust- ments during operation! Otherwise, serious per- sonal injury to you or oth- ers may occur!
1.UNPLUG THE SANDER!
2.Loosen the adjustment knobs in Figure 15 to adjust the edge sanding table height to the desired position.
3.Lock the height adjustment knobs to secure the table.
4.Plug the sander into the power supply.
5.Start the sander.
6.Hold the workpiece firmly against the flat edge as shown in Figure 16. Note— The work stop bar prevents the workpiece from running off the table.
7.For end sanding, firmly hold the workpiece against the table as shown in Figure 17.