Woodstock W1708 instruction manual Cleaning Machine

Page 12

ASSEMBLY

Cleaning Machine

The unpainted parts of the Model W1708 are coated with a waxy grease that protects them from corrosion during shipment. For optimum performance from your machine, make sure you clean all moving parts or sliding contact surfaces that are coated. Clean this grease off with a solvent cleaner or citrus-based degreaser. Do not use chlorine-based solvents— if you happen to splash some onto a painted surface, you will ruin the finish.

NEVER use flammables such as gas or other petroleum-based solvents to clean your machine. These products have low flash points and present the risk of explosion and severe personal injury!

NEVER smoke while using any cleaning solvents. Smoking may cause explosion or risk of fire when exposed to these products!

ALWAYS when using solvents with fumes, work in a well ventilated area and keep away from any potential ignition sources (pilot lights). Most solvents used to clean machinery are toxic when inhaled or ingested. Always dispose of any waste rags in a sealed container to make sure they do not cause fire or environmental hazards.

-10-

Page 11 Page 13
Image 12
Page 11 Page 13
Contents Disc Sander Page Contents Woodstock Service and Support IntroductionAbout Your New Disc Sander Warranty and Returns SpecificationsSafety First Standard Safety InstructionsDisconnect machine when cleaning, adjusting or servicing #16 #14 11-12 13-16 #12 17-20 #10 21-30 Keep stable footing and balance at all timesDisc Sander Components Machine IdentificationAdditional Safety Instructions for Disc Sanders Disc SanderElectrical Requirements 110V OperationExtension Cords GroundingAssembly Box ContentsOverview Shop PreparationCleaning Machine Adjustments Adjusting TableGeneral Information To align the table with the disc plate, do these stepsTable Tilt Replacing SandpaperTo check table tilt, do these steps To replace the sanding disc, do these stepsOperations Test RunDisc Sanding To perform sanding operations, do these stepsMiter Sanding Angle SandingTo perform miter sanding operations, do these steps To perform angle sanding operations, do these stepsMaintenance GeneralLubrication Closure 22-3 22-1 22-5 22-4 22-2 Parts List Warranty Card BOX BELLINGHAM, WA
Top Page Image Contents