Woodstock W1708 instruction manual Maintenance, General, Lubrication

Page 17

MAINTENANCE

General

Regular periodic maintenance on your Model W1708 will ensure its optimum performance. Make a habit of inspecting your sander each time you use it. Check for the following conditions and repair or replace when necessary.

1.Loose mounting bolts.

2.Worn switch.

3.Worn or damaged cords and plugs.

4.Damaged sanding disc.

5.Any other condition that could hamper the safe operation of this machine.

Table

Tables can be kept rust-free with regular applications of products like Boeshield® T-9. For long term storage you may want to consider products like Kleen Bore's Rust Guardit™.

Lubrication

Since all bearings are sealed and permanently lubricated, simply leave them alone until they need to be replaced. Do not lubricate them.

For other items on this machine, an occasional application of light machine oil is all that is necessary. Before applying lubricant, wipe the machine clean.

Your goal is to achieve adequate lubrication. Too much lubrication will attract dirt and sawdust. Various parts of your machine could lose their freedom of movement as a result.

!Disconnect power to the machine when performing

any maintenance, assembly or adjustments. Failure to do this may result in serious personal injury.

MAINTENANCE

-15-

Page 16 Page 18
Image 17
Page 16 Page 18
Contents Disc Sander Page Contents About Your New Disc Sander Woodstock Service and SupportIntroduction Specifications Warranty and ReturnsDisconnect machine when cleaning, adjusting or servicing Safety FirstStandard Safety Instructions Keep stable footing and balance at all times #16 #14 11-12 13-16 #12 17-20 #10 21-30Machine Identification Disc Sander ComponentsDisc Sander Additional Safety Instructions for Disc Sanders110V Operation Electrical RequirementsExtension Cords GroundingBox Contents AssemblyOverview Shop PreparationCleaning Machine Adjusting Table AdjustmentsGeneral Information To align the table with the disc plate, do these stepsReplacing Sandpaper Table TiltTo check table tilt, do these steps To replace the sanding disc, do these stepsTest Run OperationsDisc Sanding To perform sanding operations, do these stepsAngle Sanding Miter SandingTo perform miter sanding operations, do these steps To perform angle sanding operations, do these stepsLubrication MaintenanceGeneral Closure 22-3 22-1 22-5 22-4 22-2 Parts List Warranty Card BOX BELLINGHAM, WA
Top Page Image Contents