Woodstock W1708 instruction manual Disc Sander Components, Machine Identification

Page 8

SAFETY

7

8

9

1

2

6

5

4

3

Figure 1. Machine Identification.

Disc Sander Components

1. Base

2. Miter Gauge

3. Dust Port

4.Table Lock Handle

5.Work Table

6.Precision Ground Disc (Sanding Disc Attached)

7.Disc Guard

8.Motor

9.ON/OFF Switch

-6-

Image 8

Contents Disc Sander Page Contents About Your New Disc Sander Woodstock Service and SupportIntroduction Warranty and Returns SpecificationsDisconnect machine when cleaning, adjusting or servicing Safety FirstStandard Safety Instructions #16 #14 11-12 13-16 #12 17-20 #10 21-30 Keep stable footing and balance at all timesDisc Sander Components Machine IdentificationAdditional Safety Instructions for Disc Sanders Disc SanderElectrical Requirements 110V OperationExtension Cords GroundingAssembly Box ContentsOverview Shop PreparationCleaning Machine Adjustments Adjusting TableGeneral Information To align the table with the disc plate, do these stepsTable Tilt Replacing SandpaperTo check table tilt, do these steps To replace the sanding disc, do these stepsOperations Test RunDisc Sanding To perform sanding operations, do these stepsMiter Sanding Angle SandingTo perform miter sanding operations, do these steps To perform angle sanding operations, do these stepsLubrication MaintenanceGeneral Closure 22-3 22-1 22-5 22-4 22-2 Parts List Warranty Card BOX BELLINGHAM, WA