Woodstock W1708 instruction manual Safety First, Standard Safety Instructions

Page 6

SAFETY

SAFETY FIRST!

READ MANUAL BEFORE OPERATING MACHINE. FAILURE TO FOLLOW INSTRUCTIONS BELOW WILL RESULT IN PERSONAL INJURY.

Indicates an imminently hazardous situation which, if not avoided, WILL result in death or serious injury.

Indicates a potentially hazardous situation which, if not avoided, COULD result in death or serious injury.

Indicates a potentially hazardous situation which, if not avoided, MAY result in minor or moderate injury, MAY result in property damage.

This symbol is used to alert the user to useful information about proper NOTICE operation of the equipment.

Standard Safety Instructions

1.Thoroughly read the instruction manual before operating your machine. Learn the applications, limitations and potential hazards of this machine. Keep manual in a safe, convenient place for future reference. Make sure any other operators have read and understand the manual as well.

2.Keep work area clean and well lighted. Clutter and inadequate lighting invite potential hazards.

3.Ground all tools. If a machine is equipped with a three-prong plug, it must be plugged into a three-hole grounded electrical outlet or grounded extension cord. If using an adapter to aid in accommodating a two-hole receptacle, ground using a screw to a known ground.

4.Wear eye protection at all times. Use safety glasses with side shields or safety goggles that meet the national safety standards, while operating this machine.

5.Avoid dangerous environments. Do not operate this machine in wet or open flame environments. Airborne dust particles could cause an explosion and severe fire hazard.

6.Ensure all guards are securely in place and in working condition.

7.Make sure switch is in the “OFF” position before connecting power to machine.

8.Keep work area clean, free of clutter, grease, etc.

9.Keep children and visitors away. Visitors should be kept at a safe distance away while operating.

10.Childproof workshop with padlocks, master switches or by removing starter keys.

11.Disconnect machine when cleaning, adjusting or servicing.

12.Do not force the machine. The machine will do a safer and better job if it does the work.

-4-

Page 5 Page 7
Image 6
Page 5 Page 7
Contents Disc Sander Page Contents Woodstock Service and Support IntroductionAbout Your New Disc Sander Warranty and Returns SpecificationsSafety First Standard Safety InstructionsDisconnect machine when cleaning, adjusting or servicing #16 #14 11-12 13-16 #12 17-20 #10 21-30 Keep stable footing and balance at all timesDisc Sander Components Machine IdentificationAdditional Safety Instructions for Disc Sanders Disc SanderExtension Cords Electrical Requirements110V Operation GroundingOverview AssemblyBox Contents Shop PreparationCleaning Machine General Information AdjustmentsAdjusting Table To align the table with the disc plate, do these stepsTo check table tilt, do these steps Table TiltReplacing Sandpaper To replace the sanding disc, do these stepsDisc Sanding OperationsTest Run To perform sanding operations, do these stepsTo perform miter sanding operations, do these steps Miter SandingAngle Sanding To perform angle sanding operations, do these stepsMaintenance GeneralLubrication Closure 22-3 22-1 22-5 22-4 22-2 Parts List Warranty Card BOX BELLINGHAM, WA
Top Page Image Contents