Woodstock W1828 owner manual Power Connection, Power source

Page 16

SETUP

Model W1828 (For Machines Mfg. Since 4/11)

Power Connection

After you have completed all previous setup instructions and circuit requirements, the machine is ready to be connected to the power supply.

To avoid unexpected startups or property damage, use the following steps whenever connecting or disconnecting the machine.

Connecting Power

1. Turn the machine power switch OFF.

2.Insert the power cord plug into a matching power supply receptacle. The machine is now connected to

the power source.	Figure 8. Connecting power.

Disconnecting Power

1.Turn the machine power switch OFF.

2. Grasp the molded plug and pull it completely out of the receptacle. Do not pull by the cord as this may damage the wires inside.

Figure 9. Disconnecting power.

-14-

Image 16

Contents OWNERS MANUAL Page Contents Introduction Woodstock Technical SupportShop FOX 12 Disc Sander Model W1828 For Machines Mfg. Since 4/11 Controls and Features Work Table Rubber FootFor Your Own Safety Read Manual Before Operating Machine SafetyStandard Machinery Safety Instructions Safety Additional Safety for Disc Sanders Electrical 110V/120V60 Hz AmpsGrounding & Plug Requirements 50 ftSetup Needed for SetupUnpacking InventoryMachine Placement Cleaning Machine Working clearancesBench Mounting Dust CollectionPower Connection Power sourceSafety glasses to reduce the risk Test RunProjectiles thrown from this machine Could cause serious eye injury. WearGeneral OperationsBasic Controls Disabling ON/OFF Switch Operation OverviewChoosing Sandpaper Stock Inspection RequirementsGrit Type Before sanding, inspect all workpieces for the followingAttaching Sandpaper To attach the sandpaper disc, do these stepsDisconnect Sander from Power Disc SandingAccessories Disc Sander AccessoriesModel Grit Size ModelMaintenance CleaningTable & Base LubricationService Table/Disc ParallelismTools Needed To make the table and sanding disc parallel, do these stepsMiter Gauge Calibration Table Tilt CalibrationTo calibrate the miter gauge, do these steps Against the disc face, as shown in FigureTroubleshooting Problem Possible CauseInstall a coarse grit sandpaper, or strip coating off Electrical Safety Instructions Wiring Diagram Color KEYWiring Diagram Stop22-3 22-1 22-5 22-4 22-2 16-1 Main Parts List DescriptionPage Woodstock international inc. p.o. box Bellingham, Wa Warranty High Quality Machines and Tools