Woodstock W1828 owner manual Maintenance, Cleaning, Table & Base, Lubrication

Page 24

Model W1828 (For Machines Mfg. Since 4/11)

MAINTENANCE

General

Regular periodic maintenance on your machine will ensure its optimum performance. Make a habit of inspecting your machine each time you use it.

Check for the following conditions and repair or replace when necessary:

•Loose mounting bolts.

•Worn switch.

•Worn or damaged cords and plugs.

•Worn or damaged sandpaper disc.

•Any other condition that could hamper the safe operation of this machine.

Cleaning

Frequently vacuum the wood chips and sawdust from the sander, then blow-off any remaining dust with compressed air. This is especially important for the motor. Sawdust build-up around the motor is a sure way to decrease its life span.

Table & Base

Make sure that your machine is unplugged during all maintenance procedures! If this warning is ignored, serious personal injury may occur.

MAINTENANCE

Tables can be kept rust-free with regular applications of products like SLIPIT®. For long term storage you may want to consider products like Boeshield T-9™.

Lubrication

Since all bearings are sealed and permanently lubricated, simply leave them alone until they need to be replaced. Do not lubricate them.

-22-

Image 24

Contents OWNERS MANUAL Page Contents Introduction Woodstock Technical SupportShop FOX 12 Disc Sander Model W1828 For Machines Mfg. Since 4/11 Controls and Features Work Table Rubber FootSafety For Your Own Safety Read Manual Before Operating MachineStandard Machinery Safety Instructions Safety Additional Safety for Disc Sanders Electrical 110V/120V60 Hz AmpsGrounding & Plug Requirements 50 ftSetup Needed for SetupUnpacking InventoryMachine Placement Cleaning Machine Working clearancesBench Mounting Dust CollectionPower Connection Power sourceSafety glasses to reduce the risk Test RunProjectiles thrown from this machine Could cause serious eye injury. WearOperations GeneralBasic Controls Disabling ON/OFF Switch Operation OverviewChoosing Sandpaper Stock Inspection RequirementsGrit Type Before sanding, inspect all workpieces for the followingAttaching Sandpaper To attach the sandpaper disc, do these stepsDisconnect Sander from Power Disc SandingAccessories Disc Sander AccessoriesModel Grit Size ModelMaintenance CleaningTable & Base LubricationService Table/Disc ParallelismTools Needed To make the table and sanding disc parallel, do these stepsMiter Gauge Calibration Table Tilt CalibrationTo calibrate the miter gauge, do these steps Against the disc face, as shown in FigureTroubleshooting Problem Possible CauseInstall a coarse grit sandpaper, or strip coating off Electrical Safety Instructions Wiring Diagram Color KEYWiring Diagram Stop22-3 22-1 22-5 22-4 22-2 16-1 Main Parts List DescriptionPage Woodstock international inc. p.o. box Bellingham, Wa Warranty High Quality Machines and Tools