Woodstock W1828 owner manual Attaching Sandpaper, To attach the sandpaper disc, do these steps

Page 21

Model W1828 (For Machines Mfg. Since 4/11)

Attaching Sandpaper

The Model W1828 sander uses 12" diameter pressure sensitive adhesive-backed (PSA) sanding discs. These are available in a variety of grits. The sandpaper can be replaced without removing the table.

To attach the sandpaper disc, do these steps:

1.DISCONNECT MACHINE FROM POWER!

2.Peel-off the old sandpaper, and clean the disc surface with mineral spirits, and wipe dry.

3.Peel back the protective layer on one-halfof the sandpaper disc and fold it against the remaining half.

4.Slip the half with the protective layer between the disc and the table edge, as shown in Figure 14.

5.Position the exposed adhesive on the upper half of the sandpaper disc over the aluminum disc above the table. Once it is positioned evenly across the disc, press the adhesive firmly onto the surface.

6.Now rotate the disc so the lower half is above the table, peel-off the other half of the protective paper, as shown in Figure 15, then press the sandpaper disc firmly against the disc so adhesion is complete.

Figure 14. Slipping covered sandpaper

between disc and table.

OPERATIONS

Figure 15. Removing the paper backing.

-19-

Image 21

Contents OWNERS MANUAL Page Contents Woodstock Technical Support IntroductionShop FOX 12 Disc Sander Model W1828 For Machines Mfg. Since 4/11 Work Table Rubber Foot Controls and FeaturesSafety For Your Own Safety Read Manual Before Operating MachineStandard Machinery Safety Instructions Safety Additional Safety for Disc Sanders 110V/120V Electrical60 Hz Amps50 ft Grounding & Plug RequirementsNeeded for Setup SetupUnpacking InventoryWorking clearances Machine Placement Cleaning MachineDust Collection Bench MountingPower source Power ConnectionTest Run Safety glasses to reduce the riskProjectiles thrown from this machine Could cause serious eye injury. WearOperations GeneralBasic Controls Operation Overview Disabling ON/OFF SwitchStock Inspection Requirements Choosing SandpaperGrit Type Before sanding, inspect all workpieces for the followingTo attach the sandpaper disc, do these steps Attaching SandpaperDisc Sanding Disconnect Sander from PowerDisc Sander Accessories AccessoriesModel Grit Size ModelCleaning MaintenanceTable & Base LubricationTable/Disc Parallelism ServiceTools Needed To make the table and sanding disc parallel, do these stepsTable Tilt Calibration Miter Gauge CalibrationTo calibrate the miter gauge, do these steps Against the disc face, as shown in FigureProblem Possible Cause TroubleshootingInstall a coarse grit sandpaper, or strip coating off Wiring Diagram Color KEY Electrical Safety InstructionsStop Wiring Diagram22-3 22-1 22-5 22-4 22-2 16-1 Description Main Parts ListPage Woodstock international inc. p.o. box Bellingham, Wa Warranty High Quality Machines and Tools