Woodstock M1054 owner manual Chip Tray, Feed Stop, Recommended Adjustments

Page 24

SETUP

Chip Tray

The chip tray fits over the lip of the base as illustrated in

Figure 11.

Feed Stop

Depending on how the Model M1048 was shipped, it may be necessary to adjust the feed stop before the test run. The blade should not make contact with any part of the vise assembly.

To adjust the feed stop bolt, do these steps:

1.Adjust the feed stop bolt and jam nut (Figure 12), so the bandsaw blade teeth are 1⁄16" below the vise table surface.

Recommended

Adjustments

The adjustments listed below have been performed at the factory. However, because of the many variables involved with shipping, we recommend that you at least verify the following adjustments to ensure accurate cut- ting results.

Step-by-step instructions on verifying these adjustments can be found in the SERVICE section.

Factory adjustments that should be verified:

1.Blade Tracking (Page 29).

2.Blade Guide Bearings (Page 30).

-14-

M1048 10" x 18" Metal Cutting Bandsaw

Figure 11. Chip tray installation.

Feed Stop

Jam Nut

Figure 12. Feed stop.

Image 24

Contents Model M1054 10 x 18 Metal Cutting Bandsaw Manual Insert Copyright October, 2010 by Woodstock INTERNATIONAL, INCMachine Specifications Cutting Capacities Parts Breakdown Model M1054 Mfg. Since 4/10 Parts List DescriptionSAW BOW XPN03M Bandsaw Page Contents Maintenance Specifications IntroductionWoodstock Technical Support Controls and Features Control Panel M1048 control panelSafety Standard Safety InstructionsAlways Lock Mobile Bases if Used Before Operating Machinery Additional Safety Instructions for Bandsaws Electrical 220V OperationExtension Cords GroundingSetup UnpackingInventory Box Inventory Figure QtyMachine Placement Cleaning MachineMounting to Shop Floor Bolting to Concrete FloorsTo setup the workstop do these steps Moving & Placing UnitShipping Bracket WorkstopRecommended Adjustments To adjust the feed stop bolt, do these stepsFactory adjustments that should be verified Chip TrayTest Run To test run the bandsaw, do these stepsOperations GeneralVise To rapidly change the vise jaw gap, do these stepsTo adjust the positive stops, do these steps Squaring vise to blade Rear Vise Jaw StopTo adjust the rear blade guide arm Blade Guide ArmsBlade Selection To select the correct blade TPI do these stepsBlade Speed Feed RateTo change blade speeds, do these steps To set the feed rate, do these stepsCoolant System Coolant system reservoir Cover Coolant Control ValveCutting Fluid Biological and PoisonBandsaw Accessories Operation TipsTips for horizontal cutting Maintenance CleaningLubrication Make Sure that your machineTo change the gear oil, do these steps Gear boxService TroubleshootingBandsaw Operations Blade Change To change the blade on the bandsaw, do these stepsTo adjust the blade tracking on the bandsaw, do these steps Blade Tension & TrackingTo adjust the blade guide bearings, do these steps To adjust the blade guide roller bearings, do these stepsBlade Guide Bearings Squaring Blade to Table To square the blade the to the table, do these stepsLimit switch SQ1 Electrical ComponentsModel M1048 220V Wiring Diagram OFFGuides Blade Guides Parts List PART# DescriptionDrive Wheel Parts Breakdown Drive Wheel Parts List Breakdown Main Parts List XPSB30M CAPSCREWM6-1X45 Label Placement Warranty Warranty Registration CommentsBOX BELLINGHAM, WA