:_`gKiXp :Xjk@ife Jkfg
The chip tray directs small workpieces into a bucket when the cut is complete. The cast iron stop allows you to repeat cuts at the same length.
Kf`ejkXcck_\Z_`gkiXpXe[ZXjk`ifejkfg#[fk_\j\ jk\gj1
(% Position the chip tray, as shown in =`^li\().
)% Insert the stop rod approximately 3⁄4" into the saw until the end of the rod is just flush with the inside casting surface, as shown in =`^li\(*.
*% Use a 4mm hex wrench to tighten the set screw shown in =`^li\(*.
+% Slide the cast iron stop onto the stop rod and tighten the set screw in the side of the stop, as shown in =`^li\(+.
Chip Tray
=`^li\()% Chip tray installed.
J<KLG
Set Screw
=`^li\(*% Installing stop rod.
Set Screw
=`^li\(+% Cast iron stop installed.