Woodstock M1013 manual cj#=\\k#Xe XY`e\k

D('(*Fne\ijDXelXcD]^%J`eZ\-&'0

N_\\cj#=\\k#Xe[ :XY`e\k

J<KLG

This bandsaw is shipped with four rubber feet with posts and two wheels with an axle. It is your option to install four rubber feet if you do not need to move the bandsaw, or install the axle and wheels if you need to move the bandsaw regularly.

Kf`ejkXcck_\n_\\cj#]\\k#Xe[k_\ZXY`e\k#[fk_\j\ jk\gj1

(% At the end of the base with the axle holes, insert the axle into the base (see =`^li\+).

)% Slide a 17mm flat washer and wheel onto each end of the axle, followed by another 17mm flat washer and cotter pin.

*% Thread a 3⁄8-16 hex nut on both rubber feet.

+% Thread rubber feet into the base (see =`^li\+).

,% Position the base on the floor, and adjust the feet until the base is level and stable.

-%Tighten the hex nuts against the base to lock the feet in position.

.% Position the front and rear panels on the base and install the panels to the base with four M6-1 x 12 Phillips head screws and 6mm flat washers, as shown in =`^li\,.

/% Position the left panel between the front and rear panels, and secure it in place with six M6-1 x 12 Phillips head screws and 6mm flat washers, as shown in =`^li\-.

=`^li\+% Installing wheels and feet.

=`^li\,% Front and rear panels installed.

=`^li\-%Left panel installed.

-12-