Woodstock M1013 manual FGI8K@FEJ

D('(*Fne\ijDXelXcD]^%J`eZ\-&'0

,% Adjust the cast iron stop for duplicate cuts and install the ejector chute if required.

-%Loosen the headstock lock lever (=`^li\)+), and swivel the headstock to the needed angle of cut, and lock the lever in place.

.% Set the blade guide so the guides hold the blade close to the workpiece, and the blade will not twist with a cutting load (refer to 9cX[\>l`[\j on GX^\(0 for detailed instructions).

/% Open the feed ON/OFF valve and turn the feed rate knob so the feed rate is correct, based on your observations of the blade chip characteristics. Refer to =\\[IXk\ on GX^\), for detailed instructions.

Note: When the cut is complete, the ON/OFF switch push lever will shut F== the bandsaw.

Lock Lever

=`^li\)+% Headstock swivel system.

FG<I8K@FEJ

-22-