Woodstock W1679 instruction manual Dust Port, Installing Fence

Figure 12. Pulley and V-belt alignment.

Figure 13. Dust port mounting holes.

Fence

Support

Key

Figure 14. Installing key into fence support.

4.Halfway between the two pulleys, lightly squeeze each side of the belt together to check the tension.

Belt too loose? If each side of the belt squeezes toward each other more than 1⁄2", increase the tension by repeating steps 2 and 3.

DO NOT over-tighten the belt! Do not use pry bars or any other device to force the motor down as this may over-tighten the belt, which may damage the balance of the motor shaft or bearings and increase the wear of the power transfer components.

5.Check the V-belt pulley alignment. Minor adjustments may be made by loosening the pulley setscrew and sliding the pulley along the shaft. See Figure 12 for details.

Dust Port

Using the (4) phillips head screws from the hard- ware bag, attach the dust port over the dust chute at the mounting holes shown in Figure 13.

Installing Fence

1.The fence support key has a roll pin fitted in the center. Install the key into the fence support keyway and fit the roll pin into the provided hole. Figure 14 shows the key installed correctly.

2.Get a friend to help you lift and place the fence on this support.

NOTICE

Do not slide the fence across the outfeed table. Scratching will result.

3.Locate the threaded hole on the back of the infeed side of the fence and install the fence tilt knob into the fence.

-13-

ASSEMBLY