Woodstock W1679 Belt Guard, Knife Gauge, Control Pedestal, To assemble the knife gauge

Page 17

Figure 18. Attach belt guard to stand

with the hex bolt.

Figure 19. Knife setting gauge.

Belt Guard

Attach the belt cover to the cabinet stand with the 5⁄16"-18 x 21⁄2" hex bolt as shown in Figure 18.

Make sure that your machine is unplugged during all assembly pro- cedures! If this warning is ignored, serious per- sonal injury may occur.

Knife Gauge

The knife gauge consists of a steel rod, two adjuster arms and two E-clips.

To assemble the knife gauge:

1.Insert the steel rod through each adjuster arm.

2.Snap the E-clips into the grooves at the ends of the steel rod so your assembly looks like the knife gauge shown in Figure 19.

See page 16-17 for usage instructions.

ASSEMBLY

Control Pedestal

1. Mount the control pedestal to the back of the cabinet stand as shown in Figure 20.

2. Secure the control pedestal with the (4) 5⁄16" hex nuts and (4) 5⁄16" washers from the hardware bag.

Figure 20. Mounting pedestal switch to stand.

-15-

Image 17

Contents Jointer Page Table Of Contents About Your New Jointer Woodstock Service And SupportIntroduction Machine Specifications Warranty And ReturnsStandard Safety Instructions SafetyKeep your footing stable and keep your balance at all times #18 #16 #14 11-12 13-16 #12 17-20 #10 21-30Additional Safety Instructions For Jointers Never surface plane without push blocks Avoiding Potential InjuriesGrounding 110V OperationExtension Cords NEMA-style 6-15 plug and outlet 220V OperationUnpacking Assembly InstructionsBox Contents Shop Preparation Cleaning Machine Mounting Jointer Installing V-BeltBeginning Dust Port Installing FenceCutterhead Guard Installing lock knob and special nut PivotKnife Gauge Belt GuardControl Pedestal To assemble the knife gaugeChecking Knives AdjustmentsTo adjust the knives Unplug the jointer Adjusting KnivesTo adjust the table gibs Unplug the jointer Adjusting TablesTo adjust the outfeed table Unplug the jointer Table GibsInfeed table even with outfeed Scale can now be set to To adjust the infeed tableFence Stops To check/adjust the fence stops Unplug the jointerBasic Operations OperationsStarting Jointer Operation Musts Only plane clean stockTo perform a surface planing operation Surface PlaningTo perform an edge jointing operation Edge JointingTo perform a bevel cutting operation Bevel CuttingTo perform a rabbet cutting operation Rabbet CuttingTable Surface MaintenanceGeneral Sharpening Knives LubricationReplacing V-Belt To replace the V-belt Unplug the jointerSymptom Possible Reason HOW to Remedy TroubleshootingFeed Direction Maintenance Parts Parts 120 112 119 104 132 103 130 XPW07 Flat Washer 5⁄16 XPB21 208 242 243 232 209 221 213 229 226 316 Infeed Table Warranty Card BOX BELLINGHAM, WA