Woodstock W1679 instruction manual Beginning, Mounting Jointer, Installing V-Belt

Page 14

Beginning

Although the main components of the Shop Fox® W1679 are assembled at the factory, some assembly is required. The following series of instructions are the recommended sequence best suited for final assembly.

Make sure that your machine is unplugged during all assembly pro- cedures! If this warning is ignored, serious per- sonal injury may occur.

ASSEMBLY

Mounting Jointer

1.Determine the best place for the jointer in

your shop and place the cabinet stand in that location.

2.With the help of a friend, lift the jointer assembly onto the stand so the cutterhead pulley is positioned directly over the slot in the top of the stand.

3.Align the mounting holes (shown in Figure 10) on the stand to the jointer assembly, and secure the jointer assembly with the (3)

3⁄8" - 16 x 3⁄4" hex bolts and lock washers
from the hardware bag.	Figure 10. Secure table to stand at these locations.

Installing V-Belt

1.Figure 11 shows the jointer motor mount bolts inside of the dust chute. Loosen the nuts so you can slide the motor up and install the V-belt.

2.With the V-belt in the grooves of both the motor pulley and the cutterhead pulley, pull the motor down tightly by hand and tighten one corner bolt.

3.Place your straightedge against the face of both pulleys, and swivel the motor as nec- essary until both pulleys line up with each other. Tighten the other three motor mount bolts.

Figure 11. Motor mount bolts inside

dust chute (two are not shown).

-12-

Image 14

Contents Jointer Page Table Of Contents About Your New Jointer Woodstock Service And SupportIntroduction Warranty And Returns Machine SpecificationsSafety Standard Safety Instructions#18 #16 #14 11-12 13-16 #12 17-20 #10 21-30 Keep your footing stable and keep your balance at all timesAdditional Safety Instructions For Jointers Avoiding Potential Injuries Never surface plane without push blocksGrounding 110V OperationExtension Cords 220V Operation NEMA-style 6-15 plug and outletUnpacking Assembly InstructionsBox Contents Shop Preparation Cleaning Machine Mounting Jointer Installing V-BeltBeginning Installing Fence Dust PortInstalling lock knob and special nut Pivot Cutterhead GuardControl Pedestal Belt GuardKnife Gauge To assemble the knife gaugeAdjustments Checking KnivesAdjusting Knives To adjust the knives Unplug the jointerTo adjust the outfeed table Unplug the jointer Adjusting TablesTo adjust the table gibs Unplug the jointer Table GibsTo adjust the infeed table Infeed table even with outfeed Scale can now be set toTo check/adjust the fence stops Unplug the jointer Fence StopsBasic Operations OperationsStarting Jointer Only plane clean stock Operation MustsSurface Planing To perform a surface planing operationEdge Jointing To perform an edge jointing operationBevel Cutting To perform a bevel cutting operationRabbet Cutting To perform a rabbet cutting operationTable Surface MaintenanceGeneral Replacing V-Belt LubricationSharpening Knives To replace the V-belt Unplug the jointerTroubleshooting Symptom Possible Reason HOW to RemedyFeed Direction Maintenance Parts Parts 120 112 119 104 132 103 130 XPW07 Flat Washer 5⁄16 XPB21 208 242 243 232 209 221 213 229 226 316 Infeed Table Warranty Card BOX BELLINGHAM, WA